CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
MACHX not programming PIC16F526 or special programming?

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
muiratinas



Joined: 13 Oct 2010
Posts: 16

View user's profile Send private message

MACHX not programming PIC16F526 or special programming?
PostPosted: Thu Nov 04, 2010 3:42 am     Reply with quote
In MACHX supported devices list
PIC16526 seems

Quote:
* Indicates this part is in beta test

@ Indicates the MACH-X can not auto-detect this part type

But when i connect it to the its ZIF socket and try to program it gives an error that;

Quote:
Error : Verification Error


Is there any special connection type, or CCS Load configuration to program that chip? If yes how it can be?

(my CCS Device Programmer Software 4.027, Firmware 0.87 and Hardware is Rev 5)

(and yes my mach x can program different chips so it's not broken Smile )
muiratinas



Joined: 13 Oct 2010
Posts: 16

View user's profile Send private message

PostPosted: Fri Nov 05, 2010 12:32 am     Reply with quote
After the technical support, with the new firmware, the problem solved =)

thanks ccs support Very Happy
nanoulate



Joined: 05 May 2011
Posts: 1

View user's profile Send private message

PostPosted: Thu May 05, 2011 8:26 am     Reply with quote
PIC24FJ256DA210 also has the * Indicates this part is in beta test issue. But it doesn´t appear in the target device list. The info says that MACH X does support this PIC. How can I make MACH X target list to show this PIC?
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group